Simplicity SLC102 Manual Del Propietário página 69


Screw on the lower brace from the bottom side of the grass catcher
3.5.2h

Into the openings in the lid, insert the handle and slide washers on to its threaded ends. Insert the piece assembled
in this way through the holes in the top bracket on the frame and secure the handle using nuts. Tighten only by hand
3.5.2i
for now.

Insert the dump lever handle into the holes in the bracket inside the grass catcher.

Into the hole in the bottom end of the lever, screw in a self-tapping bolt from the outside.
3.5.2j

Screws the lid to the frame and tighten the screws.
3.5.2k

Firmly tighten the nuts securing the handle and tighten the nuts securing the top bracket of the frame. This completes
the installation of the grass catcher.
3.5.2l
ADJUSTMENT AFTER INSTALLATION

Hold the grass catcher and hang it on the hitches on the rear plate of the machine.

Check for the correct alignment of the grass catcher with the mudguard using the arrows imprinted on the grass
catcher lid and the machine cover. Adjust any unevenness by loosening the bolts on the front tube and/or the bolts
3.5.2m
on the side struts, then even it out and retighten the bolts.
On a properly adjusted grass catcher the space between the rear plate of the machine and the front frame tube (3) (
3.5.2b) is no greater than 5 mm.
If it is not possible to align using the above described method, perform the adjustment by sliding the grass catcher hitch on the rear

plate or the bolts and brackets on the top side of the hitch.
3.6 CHECKS PRIOR TO STARTING UP
3.6.1 CHECKING THE MOTOR OIL
Prior to checking the oil level, position the mower on a horizontal surface. The oil cap is accessible after tilting open the hood. Screw
out the oil dipstick, wipe it dry, reinsert it and screw in. Then again screw it out and take the oil level reading.
The oil level must be between the two marks on the dipstick. If it is not, fill up with motor oil so that it reaches the "FULL" mark. The
motor oil type is indicated in the user's manual of the engine.
The oil level must be checked before every work session.
3.6.2 CHECKING THE BATTERY
Check the battery charge level according to the user's manual of the battery.
Oil level dipstick:
(1) - (ADD) low oil level
(2) - (FULL) maximum oil level
69