Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Drawing
:
1. Grill
2. Blade
3. Grill
4. Motor cover
5. Oscillating knob
6. Motor
7. Screw D
8. Extension pole
9. Height adjustment ring
10. Base cover
11. Base tube
12. Screw A
13. Shaft
14. Piano keys
15. Grill lock
16. Blade cap
17. Clip
18. Grill cover screw
19. Grill cover
20. Cross base
STAND ASSEMBLY
1.
Assemble the 2 base pieces as a cross. Place the standard
onto the base and fasten with the included 4 philips-head
screws(screwdriver not included)
2.
Remove the highest adjust screw, pull out the extension tube
and make sure that is does not fall back in . Push the protective cap
at the way down over the stand so it falls over the 2 base pieces.
Replace the adjust screw.
3.
Place the fan on the extension tube and fasten with the
screw.
INSTRUCTIONS FOR GRILL ASSEMBLY
2.
Place the back side of the ventilation grille on the motor
spindle. Make sure the security bolt and nut are at the bottom.
Fasten it with the fixing nut.
3.
Place the propeller as close as possible to the motor spindle
and fasten it with the fixing nut.
4.
Place the front of the grille on the rear. Check that both grilles
properly placed before you close the clamps.
5.
Secure the grill by fastening the security bolt and nut.
P-3
Publicidad
Tabla de contenido
