Publicidad
Idiomas disponibles
Idiomas disponibles
E03: No speed signal
E03
If the controller is with abnormal signal
E05: Over loading protection
Motor parts are hold then motor
can't run
E05
Running belt is hold by machine
parts
Controller is with burning smells
E06: Explosion protection
Check the voltage if it is 50% lower
E06
than normal voltage
E07: Safety key not in the position
E07
1.When running belt lean to the left, set the speed at lowest position, and adjust the rear
1.When running belt lean to the left, set the speed at lowest position, and adjust the rear
screw on the left 1-2 turns along the clockwise, until it's back to the center.
screw on the left 1-2 turns along the clockwise, until it's back to the center.
2.When running belt lean to the right, set the speed at lowest position, and adjust the rear
2.When running belt lean to the right, set the speed at lowest position, and adjust the rear
screw on the right 1-2 turns along the clockwise, until it's back to thecente.
screw on the right 1-2 turns along the clockwise, until it's back to thecente.
Belt Tension Adjustment - It is very important for joggers and runners in order to provide
Belt Tension Adjustment - It is very important for joggers and runners in order to provide
a smooth, steady running surface, if the belt tension is too high to cause noisy moving of
a smooth, steady running surface, if the belt tension is too high to cause noisy moving of
belt, please loose the left and right screws on the rears.
belt, please loose the left and right screws on the rears.
Motor cable is not connected
Current is over
Running belt adjustment
Running belt adjustment
Check the connection
Replace the controller
Replace the motor
Repair the damaged parts
If controller smells, replace
the motor.
Put the safety key in the position.
9
EN
Publicidad
