Pentair FRESHPOINT F2000-B2B Instrucciones De Instalación página 4

INSTALLATION
NOTE:
• For standard under-sink installation on 1/2" 14 NPS threads or
3/8" x 3/8" compression
• Please read all instructions and precautions before installing
and using your Filtration System
• Numbered diagrams correspond with numbered steps
1. Installing the Water Supply Adapter
The supply adapter fits 1/2"-14 NPS supply threads or
3/8" x 3/8" compression. If local codes permit, it may be used to
connect the system to the cold water supply line. If local codes do
not permit the use of the supply adapter, alternate connectors can
be obtained from your local supplier.
A. Turn off cold water supply line. If cold water line does not have
a shut-off valve under the sink, you should install one.
B. Turn on the cold water faucet and allow all water to drain from
line.
C. Disconnect riser cold water supply valve.
D. Ensure the sealing gasket is fully seated into the feed adapter
valve female thread.
E. Install feed adapter valve onto supply valve. Hand tighten only.
F. Connect the riser to the feed adapter valve.
NOTE: See Figures 1G-1H for configuring the feed adapter to
3/8" x 3/8" compression connections.
2. Selecting the Faucet Location
NOTE: The drinking water faucet should be positioned with
function, convenience, and appearance in mind. An
adequate flat area is required to allow faucet base to
rest securely. The faucet fits through a 3/4" hole. Most
sinks have pre-drilled 1-3⁄8" or 1-1⁄2" diameter holes
that may be used for faucet installation. If these pre-
drilled holes cannot be used or are in an inconvenient
location, it will be necessary to drill a 3/4" hole in the
sink to accommodate the faucet.
This procedure may generate dust which can cause
CAUTION
severe irritation if inhaled or come in contact with
the eyes. The use of safety glasses and respirator
for this procedure is recommended.
DO NOT ATTEMPT TO DRILL THROUGH AN ALL-
CAUTION
PORCELAIN SINK. If you have an all-porcelain sink,
mount the faucet in pre-drilled sprayer hole or drill
through countertop next to sink.
When drilling through a countertop, make sure the
CAUTION
area below the drilled area is free of wiring and
piping. Make certain you have ample room to make
the proper connections to the bottom of the faucet.
Do not drill through a countertop that is more than
CAUTION
1" thick.
Do not attempt to drill through a tiled, marble,
CAUTION
granite or similar countertop. Consult a plumber
or the countertop manufacturer for advice or
assistance.
A. Line bottom of sink with newspaper to prevent metal shavings,
parts, or tools from falling down the drain.
B. Place masking tape over the area to be drilled to prevent
scratches if drill bit slips.
C. Mark hole with center punch. Use a 1/4" drill bit to drill pilot
hole.
D. Use a 3/4" drill bit and drill a hole completely through sink.
E. Smooth rough edges with a file.
3. Mounting the Faucet
4 • FRESHPOINT F2000-B2B, F2000-B2M Filtration Systems Instruction Manual
1C
1G
1H
2
C
D
⁄
1
1 ⁄
1
4"
262.634.2386 | greatlakesintl.com
1A
1D
Sealing Gasket
4"
1B