Diamond BUFFET 4-6 STOCK Manual Del Usuario página 5

7. TABLE
1. Fasten the bracket to the cabinet using the screws provided for this purpose. . Grasp the bottom edge
of the shelf and turn it upwards, until it is in horizontal position. . Push the edge downwards towards the
tank until it is blocked into position (see figure 6).
8. CONNECTION TO THE MAINS
1 . Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance. 2. Ensure that the supply socket has the following characteristics:
b)
earthed. It fulfils the requirements of the rated current as set out on the rating plate.
the IEC regulations: - magnetothermal differential switch with In = nominal value as stated on the rating
plate;- Differential with Id sensitivity = 30 mA.
room. 4. The connecting cable to the appliance is H05 VVF, designed for internal use. . Connect the
plug (do not use three-way adapters and reduction adapters) (see figure 7).
9. CONTROLS
The controls of the appliance are located at the front inside a protected panel.
display the temperature in the upper cabinet.
Press button 5 "SET or P"
button 6 "UP" or button 7 "DOWN 2. Refrigeration unit switch:
3. Light switch: to switch on the internal lights.
cabinet. Thermostat: to adjust the temperature in the lower cabinet (see figure 8).
10. CHECKING CORRECT OPERATION
Check that: 1 . The plug is connected. . The refrigeration unit switch is switched on (green light on).
3 . The thermometer shows the desired temperature for the goods to be stored.
exposed to direct sunlight or to high-powered lamps. . The room temperature does not exceed that in
which the appliance is designed to work normally, i.e. +30°C, 55% r.h. (climatic class 4).
11. REPLACING THE LAMPS
1 . Switch off the appliance.
glass protective cover using a screwdriver.
socket. . Remove the lamp socket, whilst holding the fluorescent tube and the transparent protective
4
tube. . Slide out the tube and the protection from the other lamp socket that is still in position. . Replace 5
the fluorescent tube. 7. Replace everything in reverse order.
unscrew the lamp socket. . Remove the lamp socket, supporting the fluorescent tube.
out from the lamp socket still in position.
reverse order (see figure 9).
Operator's guide
3 . Ensure that there is no danger of explosion (AD) in the
Thermostat
once to display the temperature set-point, which can be changed by pressing
".
4. Thermometer:
2
2. If the tank light bulb needs to be replaced, first of all remove the frosted
3. Unscrew the two screws of the right-hand or left-hand lamp
9
11. Replace the fluorescent tube.
3
: to adjust the temperature in the upper cabinet.
to switch on the refrigeration unit.
to read the temperature in the lower
5
8. If the other lamp needs replacing,
12.
7
2
(A) attached
a)
it is properly
c)
It complies with
5
1. Thermometer: to
4. The appliance is not
6
10 . Slide the tube
Replace everything in
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO