Powerplus POWX1410 Traduccion Del Manual De Instrucciones Originale página 34

9 OPERATION
9.1 Switching on and off (Fig. 5)
Note: Before engaging the on/off switch, check the saw blade to see if it is
fitted properly and runs smoothly, and the blade clamp screw is well
tightened.

Connect the plug to the power supply.

To start the tool, depress the unlock button(5) and press the switch trigger(6).

Release the trigger(6) to turn the tool off.
9.2 Line following (Fig. 6)
A V-shaped pointer locate at the front of the base plate (14) which allow a line to be followed,
when cutting.
9.3 Depth Adjustment (Fig.7)

Loosen the cutting depth setting clamp (15) by lifting the lock lever.

Set the required cutting depth on the scale (3)

Re-clamp the lock lever (15)
9.4 Setting the guide fence (Fig. 8)
Release the lock screw for guide fence (1) on the base plate (14) and set the guide fence in
the guide fence slot (16). Set a desired width and retighten the lock screw for the guide fence
(1).
9.5 General cut

Check the specifications to ensure the suitability of the material to be cut.

Fit the correct blade ensuring it is sharp and not damaged.

Set the depth of cut.

Place the material to be cut onto a flat surface such as a workbench or table. Use a piece
of scrap material underneath if: You do not wish to damage the work surface.

Plug into mains supply.

Grasp the tool firmly and rest its metal base plate onto the surface to be cut. Ensure that
the rear half of the base plate overhangs the work surface. Do not plunge the blade into
the material.

NOTE: Never draw the tool backwards.

Very little force should be used to feed the tool along the cut. Excess force will cause
operator fatigue and excessive wear to the blade and tool. Excess force is also likely to
cause the temperature cut-out to trip, resulting in delays.

Once the cut has been finished, lift the tool from the work surface before switching off. If a
lot of dust has been created, keep switched on for a few seconds extra to allow the dust to
clear from within the tool.

Ensure that the base plate is always held flat on the material being cut. This is particularly
important at the start or finish of a cut or if thin strips are being cut where the base plate is
not fully supported.
Copyright © 2016 VARO
POWX1410
P a g e | 7
EN
www.varo.com