Glacier bay FIONA FC-6024-4W Guía De Uso Y Cuidado página 6

Installation (continued)
3
Wall installation (option 1)
CAUTION: Do not overtighten the toggle bolts (AA) as DANGER: THD Danger/Warning/Caution/Important/Note
Text.[ HelveticaNeueLT STD, 9pt.] this could break the porcelain.
NOTE: The pedestal leg (B) should be supporting the
pedestal basin (A), since mounting holes are not designed to
hold the weight of the pedestal top.
If installing directly onto the wall without a stud, use the
toggle bolts (AA).
Insert the toggle bolt (AA) with rubber washer (BB) and
steel washer (CC) loosely into the backside mounting holes
of the basin (A).
Screw the wing nut and nut (DD) back onto the toggle
bolt (AA) in the order as shown.
Place the pedestal basin (A) onto the pedestal leg (B). Place
the complete unit into the desired position on the wall at
the same time pushing the toggle bolts (AA) through the
pre-drilled holes on the wall.
With the screwdriver, tighten the toggle bolts (AA) until the
pedestal basin (A) is snug against the wall.
CC
DD
AA
BB
4
Wall installation (option 2)
DANGER: THD Danger/Warning/Caution/Important/Note CAUTION: Do not overtighten the lag screws (EE) as
Text.[ HelveticaNeueLT STD, 9pt.] this could break the porcelain.
NOTE: The pedestal leg (B) should be supporting the
pedestal basin (A), since mounting holes are not designed to
hold the weight of the pedestal top.
If installing directly onto a stud, use the lag screws (EE).
Place the pedestal basin (A) on the pedestal leg (B).
Place the complete unit in the desired position on the wall.
Place a steel washer (CC) and rubber washer (BB) onto each of
the lag screws (EE) and at the same time fasten the pedestal
basin (A) directly onto the stud by screwing the lag screws (EE)
into the stud.
Tighten the lag screws (EE) until the pedestal basin (A) is
snug against the wall.
A
B
6
CC
EE
BB
A
B