Jacuzzi Whirlpool Bath S750000 Instrucciones Para La Instalación

·
Bath Heater
(For tubs pre-plumbed with inlet heater blanks)
INSTALLATION
&
OPERATING INSTRUCTIONS
INLET SIDE OF PUMP
..,
"',-."
QI
,,~~
I
rapid
,heat
n
r'1
~
~
IMPORTANT SAFETVINSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS
WARNING - When using this unit, basic precautions should always be followed, including the following:
WARNING - This unit must be connected only to a supply circuit that is protected
by
a ground fault circuit inter-
rupter (Oft I). Such a GF'CI shouRll5eproVilted
Dyt1le
lnstalterand shOUld beteste(folllrfOutine b!fSIS. To testfhe
GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should be restored. If
the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the bathtub without the
test button being pushed, a ground current flowing. indicating a possibility of an electric shock. Do not use this
HYDROMASSAGE BATHTUB. Disconnect
the
HYDROMASSAGE BATHTUB and have the problem corrected by a
qualified service representative before using.
OPERATING INSTRUCTIONS
WARNING - Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs When the internal
temperature of the body reaches a level several degrees above the normal body temperature of 98.6°F. The symp-
toms of hyperthermia include an increase in the internal temperature of the body, dizziness, lethargy, drowsiness and
fainting. The effects of hyperthermia include:
A) Failure to perceive lleet
B) Failure to recognize the need to exit the spa or HOT tub,
C) Unawareness of impending hazard,
D) Fetal damage in pregnant women,
E) Physical inability to exrt the spa or hot tUb, AND
F) unconsciousness resulting in danger of drowning.
WARNING - The use of alcohol, drugs or medication can greatly increase the risk of fatal hyperthermia.
INSTALLATION
WARNING - Please be aware if the bathtub isn't pre-plumbed with a heater blank, the installation of an Inline
Heater will void the bathtub's Intertek ETL SEMKO listing to UL Standards.
1
85-0123-3A
I
Rev.1
Jacuzzi Whirlpool Bath" BE97000C 9/05