Using Without My Needo - NEEDO T750H Manual De Uso

USING WITHOUT MY NEEDO

Fig. 01
Initial radiator start-up
The radiator, when connected to the mains electricity for the first time, goes into "network
search" mode to find a My NEEDO to bind with. To switch to manual control mode, you
must keep the button on the powerbox pressed for more than 3 seconds. The radiator
will then switch to auto-test mode (the LED flashes red slowly for 30 sec.) after which it will
automatically switch to manual operation mode.
MODE
COMFORT
BOOST
STAND BY
36
Manual control of the radiator
In the event that My NEEDO is absent or not working,
the radiator can be controlled in manual mode using
the button on the powerbox located on the lower part
of the radiator (Fig. 01). Pressing this button allows you
to select one of the radiator's three operational modes.
Selection is presented in cycles:
Stand-by -> Comfort -> Boost -> Stand-by -> ...
LED STATUS
FIXED RED (temperature
under the set-point)
FIXED GREEN (temperature
above the set-point)
SLOW FLASHING RED
OFF
APPLIANCE STATUS
Normal operation mode, set-point
fixed at 21°C
The radiator works at 100% for two
hours, then switches to Comfort
mode
Device disabled