Publicidad
Idiomas disponibles
Idiomas disponibles
Issue
Coffee tastes burnt.
Milk froth quality varies
considerably.
Appliance is not
dispensing milk froth.
Appliance is not
dispensing drinks.
Water has dripped
inside at the base of
the appliance.
Brewing unit cannot be
removed.
Grinder will not start.
Cause and troubleshooting
Grinding level is set too fine.
Set a coarser grinding level.
▶
→ "Setting the grinding level", Page 19
Type of coffee is not optimal.
Change the type of coffee.
▶
Milk froth quality depends on the type of milk or plant-
based alternative used.
Optimize the result through the selection of the milk
▶
or plant-based drink type.
Heavy build-up of limescale in the appliance.
Descale the appliance.
▶
Milk frother is soiled.
Clean the milk frother in the dishwasher.
▶
Milk frother is not inserted in the milk.
Use more milk.
1.
Check whether the milk frother is inserted in the milk.
2.
Slide the outlet system right down.
3.
Air in the water filter.
Immerse the water filter in water with the opening
1.
facing upwards until no more air bubbles escape.
Reinsert the filter.
2.
Firmly press the water filter straight down into the
▶
tank connection.
Residues of limescale remover are blocking the water
tank.
Remove the water tank.
1.
Clean the water tank thoroughly.
2.
Drip tray was removed too soon.
Wait a few seconds after the last drink was dispensed
▶
before removing the drip tray.
Locking mechanism cannot be released, brewing unit is
jammed.
Switch the appliance off and back on after 3 minutes.
▶
Appliance is too hot.
Disconnect the appliance from the power supply.
1.
Wait 1 hour so the appliance can cool down.
2.
Troubleshooting en-us
31
Publicidad
