GreenWorks G40HT Manual Del Operario página 5

EN
1 DESCRIPTION
1.1 PURPOSE
This machine is intended for cutting and trimming hedges and
bushes in domestic use. It is not intended to be used for
cutting above shoulder level.
1.2 OVERVIEW
Figure 1
1 Rotating button
2 Blade
3 Guard
4 Front handle
5 Micro switch
2 SAFETY
Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3 INSTALLATION
3.1 UNPACK THE MACHINE
It is not necessary to assemble the machine.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove the machine from the box.
4. Discard the box and package in compliance with local
regulations.
3.1.1 INSTALL THE BATTERY PACK
Figure 2
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
6 Battery release button
7 Trigger
8 Rear handle
9 safety lock button
WARNING
WARNING
WARNING
English
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.1.2 REMOVE THE BATTERY PACK
Figure 2
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
• Touch the blade carefully.
• Do not put your fingers into the notches or in position
where they can get cut.
• Do not touch the blade unless you remove the battery
pack.
• Do not use the machine if the blade is damaged or bent.
• Remove all objects such as cords, lights, wire, or string
which can become entangled in the cutting blade and
create a risk of personal injury.
If the blade jams on an electrical cord or line, DO NOT
TOUCH THE BLADE! IT CAN BE LIVE AND
DANGEROUS. Do the steps below:
1. Hold the insulated rear handle or put the machine down
and away from you.
2. Disconnect the electrically service to the damaged line
or cord before you try to free the blade.
4.1 START THE MACHINE
Figure 3.
1. Push and hold the micro switch with one hand.
2. Push the trigger and the safety lock button with the other
hand.
3. Release the safety lock button.
Hold the machine with two hands during operation.
4.2 STOP THE MACHINE
Figure 3.
1. Release the trigger to stop the machine.
4.3 TURN THE REAR HANDLE
Figure 4.
You can use the rotating button to adjust the rear handle to
different positions to cut the hedges easier.
1. Pull the rotating button and turn the rear handle.
4
WARNING
WARNING