Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARATION
Tools required for assembly (not included):
• tape measure
• electric drill with #2 drill bit (A)
• level
• (x2) #8 x 2" screws (B)
• (x2) wall anchors - if the vanity will not be screwed to wall studs (C)
• silicone (optional) (D)
Estimated installation time: 2-1/2 hours (including removal of old vanity if applicable)
WARNINGS & CAUTIONS
WARNING:
Two people are required for safe installation. Take extra
precautionary measures to ensure a secure grip on the vanity
base and top when lifting.
CAUTION:
• The bathroom floor and wall must be finished prior to
installation of the vanity base and top.
• Do not use water that exceeds temperatures of 140°F/46°C.
• Do not place any sharp or abrasive objects on the bare surface
of the vanity top.
INSTALLATION
Model 30158 shown in illustrations
1: Removing old vanity (if applicable): 1) Turn off the water supply and take the drain out. 2) Disconnect the supply lines from the faucet.
3) Remove the old vanity top and vanity. If the new vanity is not installed immediately, temporarily stuff a rag into the drain pipe.
2: Using a level, locate any uneven floor and/or wall areas where your vanity will be installed. Unevenness can cause your vanity to
become misaligned resulting in twisting of the cabinet. Repair any uneven areas by reducing high spots or shimming low spots.
3: 1) Place the vanity in the desired position taking into account the location of your plumbing. 2) Ensure the vanity is level front to back
and at both sides.
4: Attach the knobs for the doors by using the 1" screws, and the knobs for the drawers by using the 1-1/2" screws. Figure 1.
5: Secure the vanity to the wall by inserting (x 2) #8 x 2" screws (B - not included) through the back rail of the vanity. Figure 2. It is
recommended that the vanity be installed to at least one wall stud. If you are unable to locate wall studs, it is recommended that you
use wall anchors (C - not included) to secure the vanity.
6: Place the vanity top centered on the vanity base. Figure 3. For additional stability, clear silicone (D - not included) may be used to
secure the vanity top onto the vanity base.
7: Connect the faucet and drain (both not included) as per the instruction sheets provided with those items and ensure that there is
no leakage.
Figure 1
CARE & MAINTENANCE
• To maintain the beauty of the furniture finish, avoid placing the
vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by
installing away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base
immediately with a clean, soft and dry cloth.
• Clean the vanity top only with non-abrasive cleaners or
mild detergents - do not use powder cleansers. For
extremely stubborn stains, use a small amount of
acetone on a cloth and gently rub out the stain.
C
A
B
D
C
A
B
Figure 2
Publicidad
