Publicidad
Idiomas disponibles
Idiomas disponibles
10 OPERATION
10.1
Instructions for use
▪
Clamp the workpiece. Make sure that the side which will be visible later is facing down,
because the cut is most accurate at that side.
▪
Switch on the machine before it touches the workpiece. Do not exert pressure on the saw
blade. Allow the machine enough time to cut the workpiece.
▪
Hold the machine with both hands using both grips. This ensures optimum control over the
machine.
▪
For straight cuts along a drawn line use the marking for straight cuts.
▪
For bevel cuts along a drawn line use the marking for bevel cuts.
10.2
Switching on and off (Fig. 8)
Before engage the ON/OFF switch, check that the saw blade is properly
fitted and run smoothly, the blade clamp screw is well tightened.
▪
Connect the battery pack to the cordless circular saw and ensure it firmly.
▪
To switch the tool on, keep the lock-off button (5) depressed and press the on/off switch
trigger (6).
▪
To switch the tool off, release the on/off switch trigger.
10.3
Dust extraction
A vacuum cleaner can be connected to the dust extraction outlet, either directly to the
connector or using an adapter.
▪
If necessary, connect an adapter to the extraction outlet.
10.4
Cross-cutting
When making a cross-cut or a rip cut, align the guideline with the blade-guide notch on the
base. Since blade thicknesses vary, you should always make a trial cut in scrap material along
a guideline to determine how much the guideline must be offset from the guide to produce an
accurate cut.
NOTICE: The distance from the cutting line to the guideline is the amount by which the guide
should be offset. Use a guide when making long or wide rip cuts.
10.5
Bevel cutting
▪
Align the line of cut with the 45° blade guide notch on the base when making 45° bevel
cuts.
▪
Make a trial cut in scrap material along a guideline to determine how much you should
offset the guideline on the cutting material.
▪
Adjust the angle of the cut to any desired setting between 0 and 45°.
10.6
LED work-light
The LED work-light (23) will light up when pulling the trigger switch. It keeps the work area to
be lighted during your operation.
WARNING: Do not stare directly at the light beam. Never aim the beam at
any person or an object other than the work piece.
Do not deliberately aim the beam at personnel and ensure that it is not
directed towards the eye of a person for longer than 0.25s.
Copyright © 2022 VARO
POWDP25230
P a g e
| 10
EN
www.varo.com
Publicidad
