Publicidad
1. INSTALLATION
2. STEPS
1 > Preparation. Please clean the tank and pipe concerned if it is old one.
2 > Installation
1. Twist the screw and adapter out of threads and take out the washer rstly; then
put the valve into the tank inlet hole and take the triangle washer into the threads;
And then adjust the inlet valve to the right positionand screw into the nut and
adapter tightly.
2. Water lever adjustment: the adjustment screw by hand or with screw driver,
move the inlet oat and outer oat properly. The higher the inner oat and outer
oat are, the higher the water level is.
3. Twist the main body out of the base.
4. Screw the nut out of threads and take out of washers; Put the base into the tank
hole and adjust to the right position; And then screw the nut and seal washer into
the threads, meanwhile keep seal on the tank hole tightly.
5. Put the ush valve into base and take the re lling pipe into groove.
6. Insert the button into the hole and turn and adjust it to be right height; Make sure
the rod just touch the ush valve.
7. Adjust the rod relevant to touch the buttons concerned.
3. FLUSH VOLUME ADJUSTEMENT
1. Half ush volume adjustement
Clip
Lock the half ush oat with half ush volume adjustment rod by
pushing the clip; Pull the clip out, then adjust the half ush oat
position by moving it up and down.
The position of half ush oat sets half ush volume biggest ush
Half ush
boat
volume when the half ush oat at the bottom. Smallest ush
volume when the half ush oat on the top. The higher the half
ush oat is, the higher the residual water level of half ush is,
while the smaller the half ush volume is.
*Fill valve
Button
Flush valve
1
Inlet nut
Inlet washer
3
Main body
Base
5
6
Fill tube
Cap hole
2. Full ush volume adjustement
Full adjustable piece
2
4
Nut
7
Full ush
Button
Flush valve
Full rod
Full button
The bigger or smaller of hole as indicated leads to the ushing
volume.
The higher of piece, the bigger of hole, the less of ushing
volume.
The lower of piece, the smaller of hole, the more of ushing
volume.
Adjustement screw
Level
Innlet oat
Outer oat
Seal wahser
Plastic washer
Half ush
Screw
Half rod
Half button
Publicidad
