Build and fasten the pin corresponding to the set of parts XO, VO, MO-1, MO and UO in the LO and
LO-1 louver end cap. Make sure that the pin is fitted in the correct direction for the LO part and for
the LO-1 part, as shown in the diagram.
Use a screwdriver and the ZO-2 bit to help insert the XO bolt into the UO nut.
Repeat the operation 48 times with the LO parts and 50 times with the LO-1 parts.
To avoid injury and to ensure that the operation is not too difficult, we recommend holding the nut
with the ZO-5 key during this operation.
×48
×50
LO
×2
LO-1
KO
XO
VO
MO
UO
ZO-2
MO-1
LO-1
ZO-5
UO
LO
VO
XO
MO
ZO-5
ZO-2
MO-1
37