Publicidad
Idiomas disponibles
Idiomas disponibles
3. INSTRUCTIONS FOR USE
Note
◊
For mounting the product, you will need a Phillips screwdriver.
3.1 Mounting foot and upright
1.
Insert the lower tube (#8) through the hole in the base cover
(#9) and base (#10). Make sure that the end of the lower tube
(#8) points down with the welded plate and is inside the base
(#10). Attach the lower tube and base together with the washer
(#11) and the L screw (#12).
2. Install the middle tube (#7) on top of the lower tube (#8).
Loosen the fastener (#4), pull the straight tube (#3) up from
the inside of the upper tube (#5). If the straight tube (#3) is too
tight to pull out, use tools to pull the tube out of the inside of the
top tube (#5). Screw on the outer fastener (#4) clockwise. Next,
install the upper tube onto the middle tube (#7).
3. Attach the bracket (#15) to the straight tube (#3) with the
screw (#16). Next, insert the straight tube (#3) into the hole at
the bottom of the control box (#1) and attach them together
with the screw (#2).
4. Turn the outer fastener (#4) counterclockwise and adjust it to
the desired height. Then tighten it clockwise.
5. Clamp the power cable with the cable clamps (#13).
3.2 Wall mount
1.
Drill four holes in the desired location
for the wall bracket. Make sure there
are no gas, water or power lines
running through the wall.
2. Insert the dowels (4) into the holes.
Secure the wall bracket (2) with the
corresponding screws (3).
3. Connect the heating element (C) to
the wall bracket and secure the two
parts with the thumbscrew (5).
A
2
3
English
1
15
16
14
3
4
5
6
13
7
8
9
10
11
12
OFF
ON
1
5
C
B
4
2
ON
OFF
21
Publicidad
