Publicidad
Idiomas disponibles
Idiomas disponibles
DO NOT RINSE BLADE, TRIMMER HANDLE, OR POWER ADAPTER.
SPECIAL OIL
To maintain the blades on your BaBylissPRO
regularly with oil.
Gently place 2 or 3 drops of oil on the teeth of the blades before and after each use.
Turn the trimmer on for a minute, then turn off. Wipe off excess oil with a dry cloth. This
will help maintain sharpness and prevent damage from overheating. Oil is included in
your trimmer set. This light, natural oil was formulated specially for the BaBylissPRO
high-speed trimmer. Because it is the right oil to use, it will not slow down the blades.
Never use any other product. There is no substitute for BaBylissPRO
OF THE REACH OF CHILDREN.
ZERO-GAP ADJUSTMENT TOOL
IMPORTANT! Only ever attempt to zero gap the blades using the zero-gap tool provided
and following these instructions very precisely.
The zero-gap tool is required to adjust the blades to zero gap, which will help you
achieve a closer, more precise cut.
Step 1 – Using the screwdriver included, gently
loosen the two small screws on each side of the
blade.
FX787N IB-18020A.indd 9-10
FX787N IB-18020A.indd 9-10
trimmer, be sure to lubricate them
®
®
oil. KEEP OIL OUT
®
Step 2 – Slide the zero-gap tool over the gold fixed
blade until it is tight against the back portion of the
moving cutting blade.
Step 3 – Using your fingers on each side of the
zero-gap tool, push up until the black cutting blade
is even with or slightly below the gold fixed blade.
Be sure that the blades are aligned properly. The
teeth of the smaller blade (cutter) should rest slightly
Fig. 3
Comb (large blade)
below the upper edge of the larger blade (comb) —
they should be approximately 1/64" to 1/32" apart
(see Fig. 3). If the blades are not correctly aligned,
Cutter (small blade)
1/64" – 1/32"
they may cut or scratch your skin when trimming.
Once the blades have been aligned, tighten the
screws firmly.
Step 4 – MAKE SURE THE MOVING CUTTING BLADE
DOES NOT EXTEND PAST THE FIXED BLADE.
WARNING: IF THE CUTTING BLADE EXTENDS PAST
THE FIXED BLADE YOU COULD POTENTIALLY CUT
A CLIENT.
2023/11/1 15:18
2023/11/1 15:18
Publicidad
