Publicidad
Idiomas disponibles
Idiomas disponibles
START
button
RECORD
button
STOP
button
|
Song Select
button
tune.
tS
16
Scania
neh
oa meee
msaioe
nsimrimiredem's
i pbainacincsmiarenah
Saimin?
tai parmograhN-
me bie mes
IMPORTANT
7
The next step erases the tune in the SONG B area. Make sure that you no longer
need the tune in the SONG B area before continuing. If you need, you can abort
the recording standby by pressing the RECORD button again, without erasing the
tune.
|
:
|
8. Start playing the right hand part of a tune and recording starts automatically.
9. To stop recording, press the STOP button.
,
¢ Playing back both parts together
10.Check your performance.
If you want to listen to the recorded music (SONG A
and SONG B together), press the START button.
The both parts start to play
together.
|
Note
* You cannot record to SONG A area while listening to the playback of SONG B
area.
Playing back two different parts in SONG A and B at the
same time
_
After you recorded two different parts of a tune in SONG A and SONG B, you can
play them back at the same time by the following procedure.
|
1. While holding down the HARPSICHORD tone selector, set the POWER switch
to ON.
oe
7
2. Press the Song select button twice so that both of the SONG indicators light.
3. Press the START button.
The MEMORY
indicator lights and playback of the
both song areas start at the same time.
4. To stop playback, press the STOP button.
About memory back-up power
The Performance Memory is electronic memory, which means that it retains its
contents even when you switch power OFF, as long as power is supplied through the
AC adaptor or by batteries. This means that Performance Memory contents will be
lost when there are no batteries loaded (or when the batteries go dead) and the AC
adaptor is not plugged in (or power through the AC adaptor is interrupted for any
reason). Note the following advice to keep your Performance Memory data safe.
¢ Make sure that the batteries loaded in the keyboard never go dead.
¢ When replacing batteries, be sure to connect the AC adaptor to supply power first.
{7
Publicidad
