BGS technic 70961 Manual De Instrucciones página 6

INSTALLING
Components 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 are required for assembly
1. Fasten the C-ring (2) with the magnets on the side of the trailing arm on which the bush has
the smaller metal bracket.
2. Mount the two spacers (9) on the sleeve (7) with the screws (8).
3. Align the new bush with the press frame to the markings and pre-tension the the tool unit.
4. The bush can now be pressed into the trailing arm, taking into account the correct installation
position.
5. Pressing the bush into the trailing arm until the spacers (9) touch the trailing arm.
6. After the bush is installed, the tool can be removed and the vehicle completed.
EVIRONMENTAL PROTECTION
Dispose of this product in an environmentally friendly manner at the end of its life. Recycle
undesired materials instead of disposing of them as waste. All tools, accessories and
packaging should be sorted, taken to a recycling centre and disposed of in an
environmentally friendly manner. Check with your local waste disposal authority about
recycling measures.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Trailing arm (A) Bush (B)
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed