flow-med LumoScent Manual De Instrucciones página 6

EN INSTRUCTION FOR USE
START-UP / CHARGING
1. Plug the USB cable into a USB power supply (5V/2A) and the USB-C plug into the USB-C socket of your LumoScent.
2. Then plug the power supply into a mains socket. igreen LED4 flashes.
INFO: The device is charged and ready for operation in approx. 4 hours. igreen LED4 lights up
INFO: You can use the device mobile in battery mode or via USB connection in mains mode.
FILLING WITH WATER
3. Disconnect the power supply and then pull off the upper part.
4. Fill a measuring cup with up to 400ml of water.
5. Pour the water into the lower water container up to the mark.
6. Pull off the holder and fiber-cotton pen and submerge it for soaking.
7. Reattach the moistened stick with holder.
TIP: If desired, you can add up to 5 drops of water-soluble aroma oil.
8. Put the top part back on.
OPERATION
9. Touch the humidifier button (right button) 1x for maximum, 2x for medium or 3x for minimum moisture output. iwhite LED1 lights up
10. Touch the light button (left button) 1x for maximum, 2x for medium or 3x for low brightness. iwhite LED3 lights up
11. Touch the clock button (middle button) 1x, 2x or 3x so the running time of humidifier and light between 120 minutes,
30 minutes or continuous operation. iwhite LED2 lights up
12. Hold down humidifier button (right button) longer than 3 seconds, the humidifier switches off. iwhite LED1 shuts-off
13. Hold down light button (left button) longer than 3 seconds, the light switches off. iwhite LED3 shuts-off
SAVING AND RECALLING PRESETS
INFO: If you have set your humidifier intensity and/or the light brightness together with a runtime as desired, these can be saved as presets.
14. Keep the clock/preset button (middle button) pressed for longer than 3 seconds, the presets are saved. iLED1,2,3 flashes 3x
INFO: Your settings are now saved. If the device is switched off, you can call up the presetting as follows.
15. Touch the clock/preset button (middle button) 1x so the last saved preset is recalled.
TIP: Settings on the humidifier (intensity), light (brightness) and time can be changed at any time. However, if you want to save the presets again, proceed as
described in step 14.
MAINTENANCE AND CARE
Drain water when not in use for extended periods. Wipe with soft suede cloth and dry. Do not use aggressive cleaning agents. Clean the central ultrasonic membrane
once a week with cotton swabs.
! WARNINGS
Always disconnect from the power supply when filling, emptying and cleaning the unit - risk of electric shock! Improper interventions or repairs may result in con-
siderable danger to the user. Operate only indoors and handle with care. It can be damaged by shocks, impacts or falling from even a low height. Never immerse the
product in water or other liquids. Batteries do not belong in the hands of children. Do not heat the battery above 60 °C (140°F) and do not throw it into fire: risk of
explosion and fire! Do not short-circuit the battery. Never discharge the battery completely, this will shorten its lifetime. If the battery is to be stored for a longer period
of time, a residual capacity of approx. 30% is recommended. In case of damage, do not use the device and disconnect it from the mains! Place the device on a firm,
level, non-tilting surface with a water-insensitive surface. The mist outlet should be free and not directed at objects. This device is not intended to be used by persons
with reduced physical, sensory or mental capabilities or lack of experience and/or knowledge, unless they are supervised or have been given instructions on how to
use the device by a person responsible for their safety!
2
DISPOSAL
The disposal of this electronic
product and the installed Lithium
polymer battery must be carried
out exclusively in accordance with
the locally applicable regulations!
This device has the WEEE reg. no.
DE 47525015 and is accepted as
electronic waste at the designated
drop-off points. Do not dispose of
with household waste!