A
41
4. Add water up to level
tank in the machine.
43
5. Make sure that the portafilter (C1) is not attached. Position a
container under the coffee spout and the hot water spout, and
another under the steam wand (A7) (fig. 43).
6. Press the
button (B6) and hold until the
(B10) starts to blink.
7. Press the OK button: the corresponding indicator will blink.
8. The descaling programme starts and the descaler liquid comes
out of the spouts. The descale programme removes limescale
deposits from the inside of the machine by automatically per-
forming a series of rinses and pauses until the tank is empty.
Descaling ceases and the OK indicator turns blue. This means
that a rinse cycle must be carried out:
9. Empty the container used to collect the descaler solution
and reposition it under the spouts.
10. Remove the water tank, empty out any residual descaler
solution, rinse under running water and fill with fresh
water up to the MAX level (fig. 45). Return the tank to the
machine.
B
B (fig. 42). Now reposition the water
indicator
42
OK button. The rinse cycle starts.
11. Press the
12. Once the rinse cycle has been completed, water will stop
draining out and the machine is ready for use.
13. Empty the containers used to collect the rinse water.
14. Pull out and empty the drip tray, then reinsert it.
15. Remove the tank, fill with cold water and return it to the
machine.
16. The OK indicator turns white.
The machine is now ready for use.
Please note:
•
The descaling cycle can be started up at any time (even if
the relative indicator is not yet on).
•
Should descaling be started up by mistake, it can be
44
stopped by pressing the
seconds; the rinse cycle cannot be stopped.
•
After 30 seconds without a button being pressed, the ma-
chine exits the descaling programme automatically.
12. CLEANING THE COFFEE SPOUT (A19)
When the
that the coffee circuit needs to be cleaned. Use De'Longhi clean-
ing tabs (C9) to carry out the cleaning cycle. For more informa-
tion, visit www.delonghi.com.
1. Insert the 1-cup filter (C2) in the holder (C1) (fig. 26).
2. Position the cleaning accessory in the filter (C8) (fig. 27)
and press home.
3. Place the cleaning tab on the accessory (fig. 28).
4. Attach the portafilter to the coffee spout (A19).
5. Fill the tank(A15) with water. Make sure the drip tray (A11)
is empty.
6. Press the
tor (B11) starts to blink.
7. Press OK (B4) to start cleaning: the OK indicator blinks to
indicate that cleaning is in progress.
8. When delivery stops and the OK indicator turns blue, it is
time to run a rinse cycle.
13
MAX
45
button and holding for 10
indicator lights up (orange) (B11), it means
button (B5) and hold until the
indica-