Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
ADVANCING THE TRIMMING LINE
The trimmer features a fully automatic single line system. The line will automatically elongate every
time you turn on the trimmer.
NOTE: Bumping the head to try to advance the line will damage the trimmer and void the warranty.
off switch until the line reaches the length of the trimming line cut-off blade.
3. Resume trimming.
Adjusting the line length manually:
1. Switch off the trimmer and remove the battery.
2. Push the advance button located on the trimmer head while pulling the trimming line to manually
advance the line. The line will advance and stop. Push the button again to advance more line
(Fig. 9).
3. Push the button and pull the line out as many times as it takes to reach the line cut-off blade.
When no line end is visible:
Replace the line spool (see Spool Replacement instructions in the Maintenance section).
DEBRIS GUARD
1. The debris guard protects the operator against thrown objects during operation.
AUXILIARY HANDLE
The auxiliary handle can be set to various positions. Set the handle in such a manner that the trimmer
head is slightly tilting forwards when in the working position.
1. Loosen the auxiliary handle adjustment knob by turning it anti-clockwise.
2. Rotate the auxiliary handle to desired position. The auxiliary handle can slide up and down on the
upper shaft to adjust to a comfortable operating position (Fig. 10).
3. Tighten the auxiliary handle adjustment knob clockwise.
Advance
Button
Fig. 9
19
Publicidad
