100%Chef BRONSON Guía De Operación página 2

ENGLISH
Operation Guide
1. Stand the machine body on a flat table and avoid tilting;
2. Turn on electricity, press the red switch at the back, and the screen light will be on;
3. Trial run, press the green (start key) in front of the machine to observe whether the
machine is running properly. The indicator light and LED light will flash when running;
4. Put the capped jar into the bottom support;
5. Press (green start key) to start running, the bottom support automatically rises, the
can seaming completed, comes down, stops;
6. If there is an exception, press red (emergency pause key) ;
7. Press and hold the emergency pause key for 10 seconds, the number on the screen
will be cleared.
Sealing Height Adjustment
Caution: Please turn off the machine before any handlingtask
Steps :
According to "image 1", loosen the No. 2
part of adjusting rod towards right. For
No.1 part of adjusting rod, left is turning
down, right is turning up. Adjust it until
the cover and pressing head match tightly,
finally, turn the adjusting rod (2) to the
left to tighten it. In case of same caps and
different cans, the bottom support can be
replaced according to the type of can.
image 1