Wiha speedE PocketDrive Manual Del Usuario página 17

OPERATION
Charging
Only use the charger specified
by the manufacturer to charge
speedE® PocketDrive at an ambient
temperature of 0-40°C.
1
Switching the LED lamp on and off
2
Installing the bits or extension rod
3
The battery inside e-screwdriver speedE® PocketDrive is delivered partially
charged! Prior to first use, fully charge the battery using the cable included and
recommended charger which specified by manufacturer. The battery is protected
against complete discharge during use. If the battery is discharged, the speedE®
PocketDrive is switched off by a protective circuit and the electric screw-fastening
support ceases movement.
The LED lamp flashes to indicate low charge level (< 20%). The electric screw- fastening
support works up to a charge level of 20%. After that you can continue to use the
speedE®PocketDrive without the electric screw-fastening support.
1. Open the cover of charge port.
2. Plug in the cable into charge port of USB-C.
3. Connect the USB-A of cable with computer's USB port or power adapter and then
connect the power adapter to the power socket.
The charge level is showed on the power indicator. For this, press the power switch
for 2 seconds. If the LED indicator flashes, it means that the unit is charging. If only the
first LED flashes, it means that the state of charge is less than 45 %. If the first LED is lit
and the second LED flashes, it means that the state of charge is less than 80 %. If two
LEDs are lit, it means that the state of charge is greater than 80 %.
1. Push the clockwise or counterclockwise switch.
2. The LED lamp is illuminated for 5 s and then switches off automatically.
Do not look directly into the LED lamp.
To prevent accidental injury, do not touch the forward/ reverse and main switch while
installing or removing the bits.
1. To install the bit, push the bit or extension rod directly into the hex drive chuck until it is
installed in place.
2. To remove the bit, pull out the bit or extension rod directly.
EN
14