Battery Test - Chloride 300va Manual De Usuario

Operating manual
CAUTION: When the load is connected to the surge protected output on the rear panel, the
energy is taken directly from the mains therefore the loads will not have battery back-up if there
is a mains failure.

5. Battery Test

As soon as the UPS is connected to the mains, the battery will be charged independently whe-
ther UPS is switched on or not.
To verify the battery has been properly loaded, please follow the procedure described below:
UK
20
2. Charge the battery for 8 hours.
3. Switch on the UPS.
4. The buzzer will beep continuously and both the red LED and
the green LED will light up for 2 seconds.
1. Connect the UPS to the mains. The action of the
main relay will be heard at the same time of the
UPS' start. In normal operation, this step is alre-
ady done.
REV: 17/04/01 945014.066