FujiFilm GX680III Professional Manual De Instrucciones página 24

4. CHANGING THE FOCUSING SCREEN (Fig. 60)
The camera's standard focusing screen is an all matte screen with a
microprism center. For copy work and merchandise photography that
attach importance to horizontality and perpendicularity, a lattice-type
screen marked into 10-mm squares is available as an optional acces-
sory (extra-cost required) .
To change screens, remove the Finder Hood, release the Screen-hold-
ing Lever, lift up the screen frame , and insert the screen.
Screen-Holding Lever (Fig. 60-A)
5. CHANGING THE BELLOWS (Fig. 61, 62)
If you are using camera-front movements , use the Wideangle Bellows
and if you taking close-ups, use the Long Bellows.
To change bellows , release the Lock Lever (located in the right hand
side of the back of the lens mounting seat when seen from the film holder)
then push the Front Side Sliding Lever upward and dismount the camera
front.
Lock Lever (Fig. 61-A)
Front Side Sliding Lever (Fig. 61 -B)
Next, push the Back Side Sliding Lever upward and dismount the bel-
lows from the camera body.
Back Side Sliding Lever (Fig. 62-A)
To mount the bellows, repeat the same steps in reverse then push down
the Front and Back Sliding Levers to lock the bellows to the camera
body.
*
Be careful how you mount the bellows. The Stand-by Monitor will not
operate even if it is not mounted correctly.
6. USING THE EXTENSION RAILS (For taking close-ups) (Fig. 63)
Like a view camera, the close-up shooting scope of the GX680 ill can be
expanded by using its extension rails .
Loosen the Knob Screws on the front ends of the Focusing Rails and
remove the Front Bar.
Next, screw the Extension Rails (Optional accessory - Requires an ex-
tra-cost) to the Focusing Rails then screw the Front Bar.
Knob Screw (Fig. 63-A)
Front Bar (Fig. 63-B)
7. CHANGING THE FINDER HOOD'S MAGNIFYING GLASS (Fig. 64)
The GX680 ill 's Finder Hood is equipped with a 2.5x -magnification , - 1
diopter magnifying glass. Magnifying glasses ranging from -4 to +3 di-
opters are also available (Optional accessory - Requires an extra-cost)
so that you can choose one that exactly fits your eyesight. The magnify-
ing glass is secured to the mounting plate by means of a bayonet screw.
To dismount, turn it to the left.
Diopter-correction lens (magnifying glass) (Fig. 64-A)
Turn left to dismount (Fig. 64-B)
8. TAKING HAND-HELD SHOTS (Fig. 65)
To keep the carnera still when taking hand-held shots, hold it firmly with
both hands , focus the lens with the left hand and operate the Shutter
Release with the right thurnb.
You can keep it even steadier by using the camera's "Neckstrap
ill"
(Op-
tional accessory - Requires an extra-cost).
9. TAKING PICTURES WITH INSTANT FILMS (Fig. 66)
The GX680 ill 's Instant Film Holders will let you take pictures with Fuji
FP-100C (color)! FP-100B(mono-chrome) instant films and other peel-
apart type instant films of the same size .
To shoot with Instant Film Holder
I,
you 'll have to set the camera 's
Mode Switch to MULTI.
To shoot with Instant Filrn Holder II , you can set the Mode Switch to
either SINGLE, CONTINUE, or MULTI.
Instant Film Holder (Fig. 66-A)
Lock Lever (Fig. 66-B)
10. USING LARGE SIZE LENSES
The LF Lensboard Adapter (optional extra) lets you take pictures with
large-size lenses mounted on a Linhof Technika type lensboard .
However, shooting must be done with the mirror up because the shutter
systern differs. Set the Mode Switch to MULTI. Advance the film with
the Film Wind Button. The Film Wind Button operates under the MULTI
mode only. With the LF Lensboard Adapter used ,
A
of the camera's
LCD and the lens illustration of the film holder's LCD will blink, but the se
do not mean any trouble. You may use as it is.
The large-size lenses that can be used :
With standard rails : Fujinon eM 180, A 180, SF 180
With extension rails: Fujinon eM 210, eM 250, A 240, T 300
:;: If you are using lenses other than those just mentioned, check to make
sure the lens back element does not protrude from the back of the
lensboard because it can knock against the mirror and damage it.
:I:
IIJ
:;
Cl
Z
W
25