Beta 018330011 Manual De Uso E Instrucciones página 6

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
TECHNICAL DATA
LED LIGHT
POWER SUPPLY
LIGHT OUTPUT
AUTONOMY
CONNECTION
CHARGE TIME
TOTAL LENGTH
PROTECTION RATING
OPERATING TEMPERATURE
WEIGHT
1. ON/OFF BUTTON - Mode switch
2. USB C-type port
3. Wireless charging
4. LED light charge indicator
5. Magnet
CHARGING MODE
Lamp charge through USB
- The light must be charged only when it is switched off
- To charge the light, lift the cap of the USB port (2) positioned on the handgrip side
- Connect the cable first to the lamp and the power supply, and then to the mains socket, making sure that the mains voltage
is compatible with that of the charger as stated in the TECHNICAL DATA table.
- The LED light flashes green while the lamp is charging
- The charging is complete when the LED light turns steady green
Lamp charge with wireless charging base 1839BRW
- The light must be charged only when it is switched off
- To charge, place the back of the light on one of the two 1839BRW wireless charging bases with the magnet aligned with its
housing. If the battery warning light does not switch on or if the charging base flashes red, remove the light and try again
- The LED light flashes green while the lamp is charging
- The charging is complete when the LED light turns steady green
- When charge is completed, the lamp can be disconnected from the wireless battery charger.
6
High power LED SMD
Battery 3.7V 700 mAh, 2.59 Wh Li-ion
approx. 250 lm - High power mode
approx. 80 lm - low power mode
approx. 2 h - High power mode
approx. 8 h - low power mode
5V DC 1A-USB-C/Wireless
2 h
145 mm
IP 54, IK 07
-10°C +40°C
62 g
EN I