cecotec FAST&FURIOUS 9040 ABSOLUTE Manual De Instrucciones página 44

ENGLISH
will start.
3. Place the iron in a container or in a safe place (to collect the liquids that are generated
during the process), as the iron will carry out a complete process of the water through the
internal circuit dragging the lime sediments that may have been generated during its use
and the water tank will be partially emptied.
4. Once the descaling process is finished, the appliance will switch itself off and you can
continue ironing.
Note: in case the power supply is interrupted during the process, the steam station must
follow the following procedure:
- In the descaling process, if the programme is stopped or switched off, the descaling
indicator light will stay on and the descaling indicator light will stay on and the appliance
will emit an alarm when the machine is switched on next time. The entire machine may
not be used and may only be used after descaling. First press the automatic iron button
and the manual button at the same time, then press the machine start button, hold
down these three buttons for 5 seconds, the buzzer will beep 3 times and the descaling
indicator light keeps flashing. The descaling process will begin.
- If you live in a town with a very low water hardness (to find out the hardness in your area,
look for a map of lime hardness in Spain), and you do not think it is advisable to carry
out the decalcification process, you can omit it at your own risk. To do this, you can first
press the automatic button on the iron, and then press the switch button on the machine,
and hold the two buttons for 5 seconds to cancel the alarm. The signs of descaling will
disappear and you can continue ironing.
- During use, once the appliance has been running for 20 hours, the descaling indicator will
light up and beep to remind you that the iron needs to be descaled. To start the descaling
process of the iron, follow the steps below:
1. Fill the water tank to the maximum.
2. Press and hold both buttons on the iron and at the same time press and hold the start
button on the appliance. After 5 seconds, the lights will start flashing and the descaling
process will start.
3. Place the iron in a container or in a safe place (to collect the liquids that are generated
during the process), as the iron will carry out a complete process of the water through the
internal circuit dragging the limescale sediments that may have been generated during
use, and the water tank will be partially emptied.
4. Once the descaling process is finished, the appliance will switch itself off and you can
continue ironing.
Note
- When selecting synthetic fibres (130 ºC and steam) or silk (140 ºC and steam), when the
44 FAST&FURIOUS 9040 ABSOLUTE / FAST&FURIOUS 9050 X-TREME