Publicidad
Idiomas disponibles
Idiomas disponibles
0702645X - GB Seite 16 Samstag, 15. Mai 2004 8:34 08
The splinter guard cannot be used for certain saw
blade types (e. g., saw blades with set teeth).
Dust/Chip Extraction
The dust that is produced while working can be
detrimental to health, inflammable or explosive.
Suitable safety measures are required.
Examples: Some dusts are regarded as carcino-
genic. Use suitable dust /chip extraction and
wear a dust protection mask.
Dust from light alloys can burn or explode.
Always keep the workplace clean, as blends of
materials are particularly dangerous.
Vacuum Connection
The vacuum connection 6 is used to connect a vac-
uum hose.
When inserting the vacuum connection 6 in the base
plate 7, make sure that the plastic tip of the vacuum
connection engages in the corresponding hole of the
motor casing (see figure
F
To enable optimum dust extraction, use the splinter
guard 23.
The machine can be plugged directly into the recep-
tacle of a Würth all-purpose vacuum cleaner with
remote starting control. The vacuum cleaner starts
automatically when the machine is switched on.
The vacuum cleaner must be suitable for the material
to be worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special vac-
uum cleaner.
For external dust extraction with a vacuum cleaner,
an extraction adapter must be used as required (see
accessories). Insert extraction adapter and vacuum
connection firmly.
16
).
Cover Guard
The transparent cover guard 17 enables the collec-
tion of chips and sawdust. To achieve optimum
results, it must always be mounted when working
with dust extraction. When working without dust
extraction, do not use the dust cover 17. Otherwise
sawdust/wood chips can block the view.
Tips
For tight curves it is best to use a narrow saw blade.
When sawing metal or similar materials, apply
coolant/lubricant alongside the cutting line.
Straight Cuts in Thick Wood
– With the pushbutton for Exact Cut 11, switch on
the lateral guidance feature of the saw blade.
– Adjust the exact cutting angle with use of a com-
mercial angle gauge 20.
– Operate the machine with low feed only; the
orbital action and the stroke ensure sufficient
operational progress.
– Always guide the machine firmly against the par-
allel guide 24 or an auxiliary guide rail and
avoid lateral pressure against the handle in order
to prevent the machine from jamming.
Circle Cutter/Parallel Guide (Accessory –
see figures
)
–
G
H
With the combined circle cutter /parallel guide 24,
circular cutouts or parallel cuts in materials of up to
30 mm thickness can be made.
Maintenance and Cleaning
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the
machine and the ventilation slots clean.
In order to avoid operational malfunctions, do not
saw gypsum board from below or overhead.
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The pro-
tective insulation of the machine can be degraded.
The use of a stationary extraction system is recom-
mended in such cases as well as frequently blow-
ing out the ventilation slots and installing a resid-
ual current device (RCD).
Publicidad
