auronic AU3030 Manual De Instrucciones página 19

This product is not a substitute for treatments from a physician or physical therapist.
•
Chronic symptoms may worsen.
2.5 Electrical
If the power fails during use, turn the product off immediately and unplug the product.
•
If the surface of the product is cracked, turn off the product to avoid electric shock.
•
Check both power cord and plug regularly for signs of damage or wear, and if there is
•
any, do not use the product and have the power cord and/or plug replaced or repaired by
authorized service personnel.
Do not immerse the product, power cord or plug in water. If water does get inside or on the
•
product, turn the product off immediately and contact our customer service department.
Use and store the product so that the cables cannot be damaged.
•
To avoid electric shock, do not use the product if you suspect the power cord or plug is
•
damaged. A damaged power cord or plug should be repaired or replaced by a professional
(an authorized distributor).
Do not unplug the product by pulling the power cord. This may cause fire or electric shock.
•
If black smoke comes out of the product, unplug the product immediately. Wait until the
•
smoke is gone before removing the contents of the product and contact our customer
service department.
Do not leave the cable(s) hanging over the edge of a table or countertop.
•
Do not place the cable(s) on hot surfaces or near oil.
•
Do not tuck the cable(s) under rugs or blankets. Never lay the cable(s) in a walkway.
•
Do not move the product by pulling the cord or twist the cord.
•
Before connecting the product, make sure that the mains voltage indicated on the rating
•
plate matches that of your mains supply.
Make sure that you do not trip over the cable(s) and that the cable(s) are not kinked,
•
twisted, or stuck.
Do not leave the product unattended when in use. If you are not using the product for a long
•
period of time, turn the product off and unplug it.
3. INSTRUCTIONS FOR USE
3.1 Power on
1. Connect the DC plug to the DC connector of the product.
2. Plug the power adapter into the power outlet.
3. Turn on the product by pressing the power button.
4. Switch between different functionalities using the power button.
3.2 Functionalities
Press once: Turn the product on or off. The massage heads will rotate.
•
Pressing twice: Change the direction of rotation of the massage heads in the opposite
•
direction.
Press three times: Turn the heat function on or off. The massage heads rotate and the
•
product emits heat.
English
19