Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
. Operate pressure washer ONLY outdoors,
. Keep exhaust gas fi_omentering a confined area through
windows, doors, ventilation intakes or other openings.
. DO NOT operate pressure washer inside any building or
enclosure.
The pressure washer must be at least 5 ft. (I 52 cm) from
structures
having combustible walls and/or other
combustible
materials. Leave at least 3 ft. (92 cm) all around
pressure washer including overhead, for adequate cooling,
maintenance and servicing.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially
occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventihtion
intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 10). Prevailing winds and air currents should be
taken into consideration
when positioning
pressure washer.
Typical
P_essu_e Washer
Shown
Exhaust Port
To Start
Pressure
Washer
To start your pressure washer for the first time, follow
these instructions
step-by-step.This
starting information
also applies if you have let the pressure washer sit idle for
at least a day.
I.
Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.5 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2.
Check that high pressure hose is connected to spray
gun and pump. See "Preparing
Pressure 'Washer for
Use" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water
inlet on pressure
washer pump. Turn
ON the water.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Squeeze trigger on gun until you have a steady stream
of water.This
purges the pump of air and impurities.
6.
Attach nozzle extension
to spray gun (Figure II).
Tighten by hand.
7.
Place colored quick connect spray tips in slots on
holder that's attached to nozzle extension
(Figure 12).
8.
Choose
spray tip you want to use and insert it into
nozzle extension.
See "How to Use SprayTips'.
Publicidad
