Publicidad
Idiomas disponibles
Idiomas disponibles
HOSE ASSEMBLY
After the handle has been assembled, attach the
lower hose holder (see below). Insert the upper
hose end into the opening on the upright back.
Place the hose over the hose holder. Clip the
hose into the lower hose holder. Slide and twist
the lower hose end into the hose coupling on the
floor nozzle. Make sure hose is firmly connected
before using the vacuum.
Hose
Holder
Lower
Hose
Holder
Upper
Hose
Coupling
End
CORD ASSEMBLY
Make sure the quick release cord hanger is in
the upright position.
Lock the cord into
place by forcing it
into the locking
notch on the body
of the upper cord
hanger as shown.
This helps keep the
power cord out of
the path of the floor
nozzle.
Lockinc
Notch
Cord
Wrap the
power cord
_
around the
quick release
cord hanger
and lower cord
hanger, and
clip the plug
onto the power
cord.
OPERATING
tNSTRUCTBONS
1,
Turn the quick
release cord hanger
to either side and
down to release the
power cord.
__
uick
Release
Cord
Hanger
2, Unclip the plug from the power cord and pull
the cord off the quick release cord hanger.
Check to be sure the power cord is still locked
into the locking notch. See CORD ASSEMBLY.
3, Check to see if the cteaner has bag
installed. See DUST BAG CHANGING.
4, Hug the polarized power cord into a 120
Volt electrical outlet.
NOTE: To reduce the risk of electric shock, this
vacuum cleaner has a polarized plug, one
blade is wider than the other. This plug will fit in
a polarized outlet only one way. It the ptug does
not fit futly in the outlet, reverse the plug. if it
still does net fit, contact a qualified electrician to
instalt the proper outlet. Do not change the plug
in any way.
Persona_
Injury
and Product
Damage
Hazard!
DO NOT p_ug in if switch
is in ON
position.
Persona_
injury or product
damage
could
result.
DO NOT use outlets
above
counters.
Damage
to items in surrounding
area
could
occur.
Publicidad
