&
1.
2.
3.
4.
5.
6.
WARNING:
TO AVOID SERIOUS
iNJURY, BEFORE PERFORMING
ANY SERVICE OR
ADJUSTMENTS:
Depress clutch/brake
pedal fully and set parking brake.
Place gearshift
lever in neutral position.
Place attachment
clutch
in "DISENGAGED"
position.
Turn ignition key to "STOP" and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect
spark plug wire from spark plug and place wire where it cannot come
in contact with plug.
TO REMOVE MOWER
1. Place
attachment
clutch
in "DISEN-
GAGED" position.
2. Lower attachment
lift lever to its lowest
position.
3. Roll belt off engine pulley (M) and belt
keepers (G).
4. Remove cable (P) by depressing tab (L).
5. Remove
clutch cable spring
(Q) from
idler arm (R).
6. Disconnect
front link (E) from mower-
remove retainer spring and washer.
7. Go to either side of mower and discon-
nect mower suspension
arm (A) from
chassis pin (B) and rear lift link (C) from
rear mower bracket (D)-remove retainer
springs and washers.
CAUTION: After rear lift links are discon-
nected, the attachment lift lever will be spring
loaded. Have a tight grip on lift lever when
changing position of the lever.
8. Slide mower out from under right side of
tractor.
IMPORTANT: If an attachment other than the
mower is to be mounted on the tractor, remove
the front link (E) and rear lift links (C) from
tractor and hook the clutch spring (Q) into
the cable guide on front edge of lower dash.
TO INSTALL MOWER
Be sure tractor is on level surface and engage
parking
brake.
1.
Lower
attachment
lift lever to its lowest
position.
,_
CAUTION:
Lift lever
is spring
loaded.
Have a tight grip on lift lever, lower
it slowly
and engage
in lowest
position.
NOTE:
Be sure
mower
side
suspension
arms (A) are pointing
forward
before
sliding
mower
under tractor.
2.
Slide mower
under tractor
until it is cen-
tered under tractor.
21