Publicidad
Idiomas disponibles
Idiomas disponibles
Warning
13
indicators
The progress light that corresponds to the current operation turns
on to show the progress of the cycle.
(Pre-wash, Main-wash, Rinse, Drying)
Progress
14
indicators
Digital
15
To show the remaining time and delay time, error code etc.
display
10.2. WATER SOFTENER
Note: If your model does not have any water softener, you may skip this section.
The hardness of the water varies from place to place. If hard water is used in the
dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a water softener that uses a salt container specifically
designed to eliminate lime and minerals from the water, which would have a
detrimental or adverse effect on the operation of the appliance.
The water softener should be adjusted according to the hardness of the water in your
area. Your local Water Authority can advise you on this information.
Adjusting salt consumption
The dishwasher allows for adjustment in the amount of salt consumed based on the
hardness of the water used. This is intended to optimise and customise the level of salt
consumption.
1.
Close the door, then switch on the appliance.
2.
Within 60 seconds after switching on, press and hold the program button for more
than 5 seconds to enter the water softener setting mode.
3.
Press the program button again to select the proper setting based on the water
hardness level in your area. The setting will change in the following sequence:
H1->H2->H3->H4->H5->H6.
4.
Without operation in 5 seconds or press the Power button to complete the setup
and exit the setup mode.
Rinse Aid
If the "
" indicator is lit, it means the dishwasher is low on
dishwasher rinse aid and requires a refill.
Water Faucet
If the "
" indicator is lit, it means the water faucet is
closed.
Salt
If the " " indicator is lit, it means the dishwasher is low on
dishwasher salt and needs to be refilled.
Pre-wash
Main-wash
Rinse
Drying
23
EN
Publicidad
