Descargar Imprimir esta página

Beurer SI 40 Instrucciones De Uso página 16

Inhalador de vapor
Ocultar thumbs Ver también para SI 40:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 27
9. Push the variable steam regulator down to
produce smaller steam particles, and push it
up for larger ones.
10. Make sure that the ON/OFF switch is in the
"OFF" position. Arrange the mains cable in
such a way that no-one will trip over it. Insert
the mains plug into a suitable socket. The de-
vice must only be connected to the mains volt-
age that is specified on the type plate.
11. Select the desired mask for your application
(aroma or facial sauna mask).
12. Move the ON/OFF switch to the "ON"
position.
7. USAGE
After approx. 2 minutes, the device will start to pro-
duce steam.
Since each person's temperature sensitivity is dif-
ferent, we recommend starting use with sufficient
distance. Do not hold your face directly against the
mask. Gradually reduce the distance.
Ensure that steam does not escape from the mask
and into the eyes. As a result, it is recommended
that you close your eyes during treatment.
Treatment with aroma mask during
the cold season
During use, sit in an upright and relaxed position
at a table and not in an armchair, so as to avoid
compressing the airways and therefore impairing
effectiveness. Breathe in deeply.
Treatment with facial sauna mask for
cosmetic facial care
Sit in front of the device. Bend forward far enough
that your face is over the mask. After the treat-
ment, wash your face with cold water. Now apply
a facial cream or face mask. The open pores allow
the active ingredients to penetrate deep into the
skin. Do not use the facial sauna for more than a
total of 20 minutes per day. It is recommended that
F
2 to 3 treatments are performed per week As soon
as the production of steam starts to diminish (max-
imum duration approx. 10 minutes), turn the ON/
OFF switch to the "OFF" position.
After each use, pull the mains plug out of the
socket. Allow the device to cool down completely
(approximately 10 minutes). Clean the device and
the mask used after every use as described in the
"Cleaning and maintenance" chapter
8. CLEANING AND
MAINTENANCE
Warning
Adhere to the following hygiene instructions to
avoid health risks. The device must be switched
off, disconnected from the mains and allowed to
cool down each time before cleaning.
The device must be cleaned after
every use
1. Make sure that the device has cooled down
(approx. 10 minutes), the ON/OFF switch is in
the "OFF" position and the device has been
disconnected from the power supply.
2. Pull the cover of the device up and off by
pressing on the button above the aroma con-
tainer/return container.
3. Twist the lid anti-clockwise. Observe the mark-
ing on the lid when you do this. Remove the
lid. Empty any remaining water from the water
heater tank. Then dry it with a clean cloth or let
it air-dry completely. Residual moisture or wet-
ness represents an increased risk of bacterial
growth.
B
4. Pull out the aroma container/return contain-
er.
D
5. Clean the aroma container/return container,
the cover, the lid, the extension tube and the
mask with warm water and a mild cleaning
16

Publicidad

loading