Publicidad
R x 2
To insert the glides:
Tap the Tack Glides (R) into the Lower Side Panels (Ba and Bb) near the back. See Figure 12.
12.
Measure up 1/4" from the bottom of the unit on the back side of the Base (I) where it meets the
side panel and draw a short line. Lay the Corner Brace (T) so that its bottom edge is on the line
and screw the corner brace to the side panel and base with #8 x 5/8" Pan Head Screws (Z). Screw
Adjustable Glides (S) into corner braces. See Figure 12a.
W x 32
U x 32
To install the adjustable shelves:
Stand the unit upright. Determine the location you want to place the Adjustable Shelves (Ja).
13.
Tap the Shelf Brackets (U) into the four holes with the fl at side down to support each shelf. Install
the shelves as shown in Figure 13. You may fasten the shelves by inserting a #6 x 1/2" Undercut
Screw (W) through the hole in the bottom of the shelf bracket and screw it into the adjustable
shelf. See Figure 13a.
S x 2
T x 2
Fig. 13
Z x 8
Fig. 12
R
Ja
Ja
Ja
Ja
Ja
Ja
Ja
Ja
Z
Z
R
1/4"
T
Fig. 12a
U
W
Fig. 13a
497Wa — Page 9 — 12/13
S
Publicidad
