JBM 53112 Manual De Instrucciones página 8

EN
SETUP, OPERATION & PREVENTIVE MAINTENANCE
Setup
• Prior to each use, visual inspection (See Pg. 5) shall be made to the device by checking
for abnormal conditions, such as cracked welds, leaks, and damaged, loose, or missing
parts.
• Consult the vehicle owner's manual to determine the location of lift points.
• Be sure to set the vehicle in park with the emergency brake on and wheels securely
chocked.
• Be sure that the vehicle and the jack are on a hard, level surface.
Assembly
• If two piece handles are provided, assemble the upper section into the lower section,
line up the holes, insert and tighten the screw.
•
Insert the bottom end of handle into handle fork and securely tighten the bolt and
washer. Ensure the handle can turn freely.
Lifting
• Turn the handle/release valve clockwise to the closed position. Do not over tighten.
• Position the jack under the specified lift point.
• Begin lifting by pumping the handle up and down.
• Immediately after lifting, support the vehicle with appropriately rated jack stands.
• Turn the handle/release valve slowly counterclockwise to lower the vehicle onto jack
stands.
Lowering
• Turn the handle/release valve clockwise to the closed position. Do not over tighten.
• Pump the handle up and down to lift vehicle off jack stands.
• Remove the jack stands. Do not get under or let anyone get under the vehicle while
lowering.
• Turn the handle/release valve slowly counterclockwise to lower the vehicle onto the
ground.
· 8 ·
REF. 53112