Beta 1972/20V-13BMC Manual De Instrucciones página 10

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
Operating mode selection
The drill supports three different operating modes, which can be selected by means of ring selector (6).
Shift ring selector (6) to the SCREWING symbol.
Shift ring selector (6) to the DRILLING symbol.
Shift ring selector (6) to the IMPACT drilling symbol.
Chuck torque adjustment
When the ring (6) is in the start mode
1 (minimum torque) to value 20 (maximum torque).
The clutch is not operated if ring (6) is in the drilling or impact drilling mode.
Speed selection
The drill supports two different operating speeds, which can be selected by means of speed selector (7). Select the operating
speed with the motor switched off.
Position 1: Lower speed
Position 2: Higher speed
Connection to battery
Before connecting the tool battery, check the charge level by pressing button
- 3 LEDs on: maximum charge level
- 2 LEDs on: medium charge level
- 1 LED on: low charge level
To connect the drill to the battery, slide the tool base on the battery rails until fully inserted:
To disconnect the battery, press battery unlocking button (10) and slide the base of the drill battery, until fully removed:
Disconnect the battery after each use, and insert it into the battery charger for charging.
Charge the batteries with a charger supplied by Beta, following the relevant instructions.
10
, , chuck torque can be adjusted by means of ring (5), the clutch being set from value
:
EN I