Husqvarna 330iKL Manual Del Usuario página 14

4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen
the coupling.
2. Push and hold the button (C).
3. Hold tight to the end of the shaft that the
motor is attached to.
4. Pull the attachment straight out of the
coupling.
C
Introduction
WARNING:
understand the safety chapter
before you use the product.
14
Operation
Read and
To install the cutting attachment
guard
1. Attach the correct cutting attachment
guard (A) for the trimmer head. Refer to
Accessories on page 24 .
2. Put the cutting attachment guard onto the
fitting on the shaft.
3. Attach the cutting attachment guard with
the bolts (B).
B
Before you operate the product
• Examine the work area to make sure that
you know the type of terrain. Examine
the slope of the ground and if there are
obstacles such as stones, branches and
ditches.
A
2103 - 004 - 03.11.2023