Publicidad
Idiomas disponibles
Idiomas disponibles
LumaPro Operating Instructions
General Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
1.
2.
Review the diagrams thoroughly before beginning. If you feel you do not have electrical
wiring experience, have your fixture installed by a qualified licensed electrician.
3.
All electrical connections must be in accordance with local codes, ordinance, and the
National Electric Code. If you are unfamiliar with methods of installing electrical wiring,
secure the services of a qualified licensed electrician.
4.
Before starting the installation, disconnect the power by turning off the circuit breaker or
by removing the appropriate fuse at the fuse box. Turning the power off using the light
switch is not sufficient to prevent electrical shock.
5.
Equipment should be mounted in location and at heights where it will not readily be
subject to tampering by unauthorized personnel.
6.
Do not use this equipment for other than intended use.
7.
All servicing should be performed by qualified personnel only.
Mounting
1.
Drill three mounting holes into mounting surface using a 3/8" drill bit. Use template to
locate mounting holes.
2.
Use a screwdriver to loosen the(2) screws securing fixture door. Remove fixture rear
housing from fixture.
3.
Use a flat head screw driver to remove appropriate wire way covering from back plate of
housing.
4.
Take care to avoid damaging driver, wires and quick connectors and drill holes through
castings over fixture mounting holes.
5.
Affix fixture to mounting surface by installing anchors (not supplied) through fixture
mounting holes into holes drilled into the mounting surface. Be sure to use an anchor
appropriate for the mounting surface in which the fixture is installed.
6.
Add ¼" bead of exterior grade silicone sealant around the perimeter of the wall pack on
the wall to inhibit any moisture from attachment screws.
33H472
20W LED Full Cut Off
Wall Pack
3
LumaPro Operating Instructions
Wiring Diagrams
AC wiring instructions
Disconnect the power by turning off the circuit breaker or by
removing the appropriate fuse at the fuse box. Turning the power off using the light
switch is not sufficient to prevent electrical shock.
1.
Feed wires through wire way and secure using connector (not supplied).
2.
Connect supply wires to quick connect originating from INPUT side of driver.
Black/Hot supply to quick connect with black wire. White/Neutral supply to quick connect
with white wire. Be sure to confirm connections are secure.
3.
Connect ground wire to quick connect with green wire. Be sure to confirm grounding
connection is secure.
Installation
1.
Reattach fixture front to fixture rear housing.
2.
Connect driver OUTPUT leads to quick connect originating from LED array.
Red output to quick connect with red wires, black output to quick connect with black
wires.
3.
Reattach fixture using two Philips head screws removed in mounting step 2.
Warranty
LIMITED FIVE-YEAR WARRANTY
Should this product fail to perform satisfactorily due to a defect or poor workmanship within
FIVE YEARS from the date of purchase, return it to the place of purchase and it will be replaced,
free of charge. Incidental or consequential damages are excluded from this warranty.
33H472
20W LED Full Cut Off
Wall Pack
4
Publicidad
