Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving You can use this water-
tight shaver in the shower and clean
tin water Treat yourself to wet lather
shaves for at least three weeks and
notice the difference Your Panasonic
WET/DRY shaver requires a little
time to get used to because your skin
and beard need about a month to
adjust to any new shaving method
Parts identification
(see fig 1)
Protective cap
Mirror
Outer foil
Outer foil release button
Foil frame
Inner blade
Foil frame release button
On/Off switch
Switch lock button
Battery cover
Battery cover release dial
Cleaning brush
090000000000
Replacing batteries
Before replacing the battery, wipe the
shaver free of morsture to prevent the
inside from getting wet
1 Tumthe battery cover release dial
and remove the battery cover
(Turn the dial tn the counter clock-
wise direction and match the
mark to the open
position )
(Fig 2A)
2
Insert the two AA Alkaline batter-
tes as shown in the figure (Fi
2B) Do not use new batteries wit
old ones
3
Replace the battery cover with
the dial mark at open Check for
proper sealing of the water-proof-
ing ring
4
After replacing the battery cover
to the main unit, tum the dial mark
to close (Fig 2C)
For a better shave
Put a thin layer of ana. foam on
your face which works as
lubricator
Shaving foam is the most suitable
among many other shaving aids(gel,
soap, cream, o Do not put a thick
layer of shaving foam as it becomes
messy lí the shaving head ls clogged
with foam, simply rinse it under run-
ning water
Hold the shaver at a right angle (90°)
to your skin (see fig 3 3) Depress the
switch lock button and slide the On/
Off switch upward to turn the shaver
on
Start out shaving by applyin
gentle ER
to yourface Stretc
your skin with your free hand and
move the shaver back and forth in
the direction of your beard You may
gently increase the amount of pres-
sure as your skin becomes accus-
tomed to this shaver Applying exces-
sive pressure does not provide a
closer shave