How To Use; Warming Modes - Munchkin Shine Manual Del Usuario

How to Use

TO USE
1. Place the appliance on a flat surface, then fill
the warming chamber with COOL/COLD
(Fig. A)
water to the fill line. .
NOTE: Take care not to add too much or
too little water, which could affect the final
temperature of the bottle. DO NOT use the
(Fig. B)
appliance without adding water.
NOTE: It is important that starting water
temperature is below 70°F. If water is too warm,
the unit will beep twice upon attempting to
start warming cycle, indicating an error. If this
happens, pour water out and replace with
cooler water, wait 10 seconds and try again.
2. Place the pre-made bottle into the lift-out
basket. Be sure to push the bottle all the way
(Fig. C)
to the bottom. .
NOTE: Never place a bottle into the warming
chamber without the lift-out basket.
3. Place the lift-out basket into the warming
(Fig. D)
chamber. .
NOTE: Use of some wide-mouth bottles
may result in too much water displacement.
If water touches the basket retention tabs,
water level must be reduced so that it is
at least 1/2" below tabs. Failure to do so
before starting heating process may result
in serious injury.
6
.
(Fig. B)
max.
4. Insert the plug into an electrical outlet. Choose a
warming mode from the chart below, then turn the
control dial to the desired warming mode (refer to
WARMING MODES chart).
(Fig. A)
Bottle Size
4 oz. Standard Bottle
4 oz. Standard Bottle
4 oz. Wide Bottle
(Fig. B)
4 oz. Wide Bottle
5 oz. Standard Bottle
5 oz. Standard Bottle
8 oz. Standard Bottle
8 oz. Standard Bottle
8 oz. Wide Bottle
(Fig. C)
8 oz. Wide Bottle
9 oz. Standard Bottle
9 oz. Standard Bottle
9 oz. Wide Bottle
9 oz. Wide Bottle
(Fig. D)
(Fig. E)
.

WARMING MODES

Starting Tempurature
Room Temperature
Refrigerated
Room Temperature
Refrigerated
Room Temperature
Refrigerated
Room Temperature
Refrigerated
Room Temperature
Refrigerated
Room Temperature
Refrigerated
Room Temperature
Refrigerated
How to Use
(Fig. E)
Mode
7