Operation Method - Daitsu ADDH-10 Manual De Usuario

Operation Method

4 hour or 2 hour
delay on/off
indicator lights
Notes:
Water bucket must be correctly installed for the dehumidifi er to operate.
Do not remove the bucket while unit is in operation.
If you want to use drain hose to drain water away, please install the hose according to section
"Drainage method".
Each time pressing the effective button on the control panel will give out a "beep" sound.
When power is connected, power indicator on the control panel will be on and dehumidifi er gives
out a "beep" sound simultaneously.
Operation Method
ON/OFF Pad
Press to turn the dehumidifi er on and off.
FILTER Pad
After 250 hours of operation, the Clean the Filter indicator light will glow to
remind you toclean the fi lter. Remove the fi lter and clean it. Press to turn
off the Clean the Filter light. See the Care and Cleaning section.
Humidity Set ControlPads
The humidity level can be set within a range of 80% RH (Relative Humidity)
to 35% RH (Relative Humidity) in 5% reduce or at CO for continuous
operation.
NOTE: If CO (Continuous) is selected, the dehumidifi er will operate continuously at its maximum
dehumidifi cation settings if attached to a hose to drain or until the bucket is full.
For drier air, press the - pad and set to a lower percent value (%).For damper air, press the + pad
and set to a higher percent value (%).When you fi rst use the dehumidifi er, set the humidity control to
45% or 50%.
Allowat least 24 hours for the dehumidifi er toachieve the humidity level. If you still havedamper
air than desired, set the humiditylevel to a lower setting or select Continuousfor maximum
dehumidifi cation.
17
High, Mid and Low
fan indicator lights
Bucket full light indicates bucket
needs to be emptied or it is not in
Continuous operation on
the proper place. indicator light
Power On
indicator light
Clean the Filter
indicator light