Hitachi C 10FCD Manual De Instrucciones E Instrucciones De Seguridad página 11

2. Releasing the plunger handle
Fig. 5-a
W hen the po w er tool is prepared for shipping, its m ain parts are secured by a plunger handle. M ove the
handle slightly so that the plunger handle can be disengaged and adjusted as indicated in Fig. 5-b.
NOTE:
Lowering the handle sloghtly will enable you to disengage the plunger handle more easily
and safely.
The lock position of the plunger handle is for carrying and storage only.
For transportation purpose, grasp the handle (see Fig. 1) with one hand and hold the base at the left end
grip section with the other hand to carry.
3. Installing the dust bag, miter handle, extension wing, stock stop and vises.
(The extension wing and stock stop are optional accessories).
Attach the dust bag, miter handle, extension wing, stock stop and vise asse m bly as indicated in Fig. 1
and Fig. 2.
(1) Asse m bly of cla m p lever
Handle
Cla m p
Collar
Lever
Scre w Spring
Fig. 6
Scre w
Cla m p Lever
Fig. 7
4. Installing the extension stay
(1) Insert the extension stay into the hole of the base.
(2) Fasten the tw o 5 m m m achine scre ws and fix an extension stay as indicated in Fig. 2.
Plunger Handle
During transport, fit the
plunger handle into the
deep slot.
N O TE: This position is not be
used for any cutting
operation.
q Insert spring and screw into the hole of the cla m p lever
as sho w n in Fig. 6.
w Asse m ble the cla m p lever to the handle collar, then
tighten the scre w as sho w n in Fig. 7.
5 m m Hex. soc. hd. cap bolt (C)
(Stopper for 0°)
During operation fit the
plunger handle stoppers
into the shallo w slot.
Plunger Handle
Pull out to disengage.
Rotate the knob 1/4 turn
and fit the pin stoppers
into the shallo w slot.
Fig. 5-b
English
Clockwise
11