Publicidad
ASSEMBLING STAND
1. Attach the rubber feet (H) Fig. 11 to the bottom of
each leg (F).
Locate the two legs (F) which have holes at the
bottom for attaching the wheel brackets (G) and
brace (E). (Make sure wheels and brackets are
properly oriented. See inset Figure 11.) To attach
the brackets, remove the nuts from the bolts and
insert the bolts through the holes in the bottom of the
two legs and into the holes in brace (E). Thread the
nuts back on the bolts and tighten. Assemble the
stand as shown in Fig. 11, using 16 M8x1.25x20mm
carriage head bolts, 3/8" flat washers and M8x1.25
hex nuts. Align the holes in the stand legs (F) with
the holes in the brackets. Insert the carriage head
bolt through the hole in the leg and the hole in the
bracket, place a flat washer on the carriage head bolt
and thread a hex nut onto the carriage head bolt.
Repeat this process for the 15 remaining holes in the
legs and brackets.
NOTE: Loosely tighten the hardware for further
adjustment.
Letters are on the stand brackets to ease assembly:
A - Top front and rear brackets
B - Top side brackets
C - Bottom side brackets
D - Bottom front and rear brackets
E - Bottom brace
NOTE: Each rubber foot is provided with holes for
mounting the stand to the floor surface if required.
ATTACHING THE BAG
1. Attach the dust bag to the bag frame and place the
frame of the dust bag inside the saw stand as shown
in Fig. 12. Refer to the section below to attach this
assembly to the saw.
SAW TO STAND
1. Turn saw table face down on a piece of cardboard to
protect the table surface. Place stand upside down
onto saw and align the four holes in the stand with
the mounting holes in the saw.
2. Place a 3/8" flat washer on a M8x1.25x45mm hex
head screw. Insert the hex head screw through the
mounting hole in the saw and the mounting hole in
the stand. Place another 3/8" flat washer on the hex
head screw and thread a M8x1.25 hex nut on the
screw and loosely tighten. Complete this process for
the other three holes.
3. Stand the saw upright, as shown in Fig. 13 (Saw is
shown fully assembled here).
4. Push down on top of the saw so that the legs of the
stand adjust to the surface of the floor. Tighten all
hardware securely.
C
G
E
11
A
D
Wheel
Fig. 11
Fig. 12
Fig. 13
B
F
H
Publicidad
