Publicidad
Idiomas disponibles
Idiomas disponibles
▪
Remove the accessory in the opposite way.
Note: Check that the application tool is seated securely. Application tools
that are attached incorrectly or are not securely fixed in place may come
loose during operation, thereby putting you at risk.
WARNING: Do not use any unmatched accessories.
WARNING: Check the tight seating of the application tool/accessory.
Incorrect or not securely fastened application tools/accessories can come
loose during operation and pose a hazard.
8.2
Mounting/changing the sand paper
With fast hook and quick release system.
▪
Position the sand paper and press by hand.
▪
Press on the sand paper by giving it a short, firm push against the flat surface of sanding
plate and switch on the power tool.
− This ensures good adhesion and prevents premature wear.
▪
If the point has become worn, pull off the sand paper, turn it through 120º and place it on
again, or change the sanding paper.
Note: Check that the application tool is seated securely. Application tools
that are attached incorrectly or are not securely fixed in place may come
loose during operation, thereby putting you at risk.
9 OPERATION
9.1
Switching ON/OFF (Fig. 2)
▪
Push and slide battery pack into battery port, make sure the release latch on the rear side
of the battery snaps into place and battery is secure before beginning operation.
▪
Switching the power tool ON: slide ON/OFF switch button (1) forward onto position (I).
▪
Switching the power tool OFF: slide ON/OFF switch button (1) backward onto position (O).
9.2
Charging the battery pack
The battery pack for this tool is supplied in a low charge condition to prevent possible
problems, therefore, you have to charge the battery before first use.
Note: Batteries will not reach full charge the first time they are charged.
Allow several cycles for the item to fully charge. The battery should only be
charged indoors.
After normal use, about 1 hour of charging time is required for the battery to be fully charged.
The battery pack will become slightly warm while charging, this is normal and does not
indicate a problem.
Do not place the charger in an area of extreme heat or cold. Best is at normal room
temperature. When the battery becomes fully charged, unplug your charger from the power
supply and remove the battery pack from the charger.
Note:
▪
Allow the battery pack to cool completely before charging.
▪
Inspect the battery pack before charging, do not charge a cracked or leaking battery pack.
Copyright © 2021 VARO
POWXB40020
P a g e
| 8
EN
www.varo.com
Publicidad
