Daga SF-180 Instrucciones De Uso página 14

PORTUGUÊS
INSTRUCTIONS FOR USE
Prior to plugging in the product to the mains, check that your mains
voltage is the same as or is within the limits indicated on the pro-
duct label. The safety instructions marked at the beginning of this
manual must be followed at all times when using this product.
Follow the instructions below in order to switch on the appliance:
1. Remove the product from its original packaging together with all
its accessories taking special care not to damage any of the parts.
Do not use excessive force to remove the product from the box.
2. Place the appliance on a totally flat, horizontal, clean and dry
surface.
3. Fill the measuring cup up to the level you deem convenient
depending on the duration of the required treatment. The measu-
ring cup provides information on the amount of water necessary
depending on the treatment time. Always respect the maximum
limit marked on the cup.
4. Pour the contents of the measuring cup into the main tank,
taking care not to exceed the maximum level marked on the
appliance. Ensure that the water does not splash onto the outside of
the container during this process.
5. Fit the facial mask or the nose accessory turning it on the main
unit. The selected accessory will depend on the type of treatment
you wish to perform, over the skin or over the respiratory tracts.
6. Connect the appliance to the mains.
7. Press the ON/OFF switch to start the treatment.
8. Wait a couple of minutes until you see steam coming out of the
facial sauna.
9. Place your face on top of the facial mask or your nose on top of
the nose accessory and enjoy your treatment. We recommend you
start by approaching the appliance slowly in order to adapt to the
temperature of the steam.
You may use the intensity adjusting device during the treatment in
order to regulate the amount of steam supplied by the facial sauna.
Increase the distance between the facial mask and your face if
you feel the heat to be excessive. Improper use of this product can
cause redness on your skin or burns. In the event of burns, always
contact your doctor immediately.
When you finish using the product, either because it has totally eva-
porated or because you have decided to end the treatment before
time, press the ON/OFF switch to turn off the appliance. Wait for
approximately 15 minutes for the appliance to cool down before re-
moving, cleaning or storing the facial mask. Follow the instructions
in this user manual to clean the device.
Wash your face with cold water and apply a facial cream or face
mask after the treatment.
14