PDP REALMz 500-234 Manual De Instrucciones página 3

C. The REALMz Wireless Controller also comes with a "Collector Mode" light setting that allows you to keep the
controller's LEDs lit while the controller is connected to the Nintendo Switch dock via a USB-C cable. To enable
these settings, follow the instructions below:
a. Plug the USB side of the cable into the Nintendo Switch dock. Then, while the controller is unplugged,
hold the "function" button and D-pad right, and plug in the USB-C cable into the controller.
D. To keep the controller paired and lit for extended periods of time, you can disable the auto-sleep settings on
the Nintendo Switch. On your device, navigate to System Settings > Sleep Mode > Auto Sleep (Connected to
TV) > select "Never."
Note: When the controller and system turn off, the lighting modes reset to the default mode (the mode for the A
button).
5. Adjusting LED Light Settings
A. To adjust the LED brightness, hold the "function" button and press either ZL or the D-pad down button to
decrease brightness, or either ZR or the D-pad up button to increase brightness.
WARNING: DO NOT DISASSEMBLE THE CONTROLLER!
Disassembling the controller to remove the figurine or any other components will void the 2-year manufacturer's warranty. The
figurine is securely fixed inside the controller and is not designed for removal by users.