Publicidad
Idiomas disponibles
Idiomas disponibles
TO ASSEMBLE
GRASS
CATCHER
1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings over frame.
NOTE:
If vinyl bindings are too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
_CAUTION:
Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open.
frame
handle
Frame
opening
ENGINE
ENGINE
SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Sears or other qualified service center for
repair and adjustment.
CARBURETOR
Your carburetor
has a non-adjustable
fixed main jet for mixture
control. If your
engine does not operate properly due to
suspected
carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the
engine above the factory
high speed
setting can be dangerous.
If you think the
engine-governed
high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment
and experience
to make any
necessary
adjustments.
Immediately
prepare
your lawn mower
for
storage
at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower
is to be stored for a
period of time, clean
it thoroughly,
remove
all dirt, grease,
leaves,
etc. Store in a
clean, dry area.
1. Clean
entire lawn mower
(See
"CLEANING"
in the Maintenance
section
of this manual).
2.
Lubricate
as shown
in the Mainte-
nance section
of this manual.
3.
Be sure that all nuts, bolts, screws,
and pins are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear.
Replace
if
necessary.
4. Touch
up all rusted or chipped
paint
surfaces;
sand
lightly before
painting.
HANDLE
You can fold your lawn mower handle for
storage.
1. Squeeze
the bottom
ends of the lower
handle
toward
each other until the
lower handle
clears the handle
bracket,
then move handle forward.
2.
Loosen
upper
handle mounting
bolts
enough
to allow upper handle to be
folded
back.
IMPORTANT:
When folding
the handle
for storage
or transportation,
be sure to
fold the handle as shown or you may
damage
the control cables.
• When setting
up your handle from the
storage
position,
the lower handle will
automatically
lock into the mowing
position.
14
Publicidad
