Maclean Energy MCE504 Manual De Instrucciones página 6

OPERATING INSTRUCTIONS
To begin to use the heater, please follow these instructions:
1. Check the heater to be sure it is not damaged.
Connect the power and turn on the switch on the side of product. The OF
2.
indicator on the lower left corner of the LCD screen will be lit to enter standby
℃
mode, and the LCD screen's default setting temperature will be ST25 while
the ECO indicator will be lit, displaying the current ambient temperature.
3. Press the power button once and the "ON" indicator of the LCD screen is lit,
showing that the product is in the power-on state. At this time, if the ambient
temperature is below RT25 ℃ , the product will begin to work; if the ambient
℃
temperature is higher than RT25 , it is required to set the temperature for
the product before the product can start work.
4. Temperature setting:
① Turn on the switch on the side of the product, and the OF on the LCD
screen will be lit, showing that the product enters the standby state;
② Press the power button, and the ON indicator on the LCD screen will be lit,
showing that the product enters the power-on state;
③ Press the SET button and the temperature setting indicator flashes, then
press "+" or "-" button to set the temperature;
④ After 10 seconds of setting the temperature, the product will automatically
save the temperature and start to work.
(Note: When the set temperature is higher than the ambient temperature,
the product begins to work; when the set temperature is lower than the
ambient temperature, the product will stop working.)
6.Power-on reservation:
① Turn on the switch on the side of the product, and the OF on the LCD
screen will be lit, showing that the product enters the standby state;
② Press the power button once, and the "ON" indicator on the LCD screen will
be lit, showing that the product enters power-on state;
③ Continuously press the SET button twice and the power-on reservation
indicator "ON" will be lit. the reservation timing indicator flashes and enters the
power-on reservation status;
④ Press "+" or "-" button to set the power-on reservation time;
⑤
Ten seconds after the completion of the startup reservation setting, the
startup reservation time will be automatically saved;
7. Shutdown reservation:
① Turn on the switch on the side of the product, and the OF on the LCD
screen will be lit, showing that the product enters the standby state;
② Press the power button once, and the "ON" indicator on the LCD screen will
be lit, showing that the product enters power-on state;
③ Continuously press the SET button twice and the shutdown reservation
indicator "OF" will be lit. the reservation timing indicator flashes and enters the
shutdown reservation status;